slenderness
英 [ˈslɛndənəs]
美 [ˈslɛndərnəs]
网络 细长度; 长细比; 纤细; 名词; 细长
BNC.40473 / COCA.40756
英英释义
noun
- the property of an attractively thin person
- relatively small dimension through an object as opposed to its length or width
- the tenuity of a hair
- the thinness of a rope
- the quality of being slight or inadequate
- he knew the slenderness of my wallet
- the slenderness of the chances that anything would be done
- the slenderness of the evidence
双语例句
- Bearing behavior of cast-in-place piles with similar slenderness ratios in deep soil layer
深厚土层中长径比相近灌注桩承载性状 - The displacement ductility of the CFSSTC specimens were analyzed, the effects of the steel ratio, the slenderness ratio, and the axial compression ratio on the ductility of the CFSSTCs were studied.
同时研究了含钢率、长细比和轴压比对方钢管混凝土柱延性的影响。 - This article presents a unified analysis of the limiting slenderness of plate elements of compression members with three commonly used sections.
本文统一分析了轴心压杆三种常用截面的板件宽厚比限值。 - It is shown that the nonlinear frequency ratio increases with the vibration amplitude and the slenderness ratio.
计算结果表明非线性频率与线性频率之比随振动幅值的增大和梁长细比的增大而增大; - Impact of diameter-thickness ratio of steel tube and slenderness ratio of pier on extension, bearing capacity and energy absorbing of steel pier is studied as well.
目的研究钢管径厚比和桥墩柱长细比参数对外置钢管补强圆形钢桥墩承载力、延性和吸收能量的影响。 - A calculation method for equivalent slenderness ratio by a graphical method is presented.
给出了应用图表法的换算长细比计算方法。 - According to the relationship between the structural strength and slenderness of plate elements, the limited width-to-thickness ratio of the flange of a box-section column under seismic load is derived.
由构件承载力与壁板宽厚比的关系,得出了抗震设计箱形截面柱翼缘板宽厚比限值。 - In this paper, the bearing capacity and failure modes of long angle steel truss concrete columns with different eccentricities and slenderness ratio are studied.
本文对不同偏心距和长细比的内含角钢桁架混凝土长柱在偏心荷载作用下的承载力和破坏情况进行了研究。 - But the slenderness of that base also means that insolvency threatens when bad times arrive.
但这个基数的微薄程度也意味着,在市况不好的时候,资不抵债的危险就会出现。 - Research on Determining slenderness ratio of members of superhigh voltage transmission steel tubular towers
特高压钢管输电塔构件长细比取值研究